Yard-Man YM20CS User Manual
Page 6
6
For decorative trimming/edging with the line head cutting
attachment, lock the release button of the cutting attachment
into the 90° hole (Fig. 8).
OPERATING THE EZ-LINK™ SYSTEM
The EZ-Link™ system enables the use of these optional Add-
Ons.
Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GC720r
Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LE720r
Hedge Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TPAH*
Straight Shaft Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . SS725r
Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TB720r
Pole Saw . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TPPS*
Brushcutter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .TPBC*
*Do NOT use this attachment with an electric powered
product.
Removing the Cutting Attachment or Add-Ons
1.
Turn the knob counterclockwise to loosen (Fig. 6).
Fig. 6
EZ-Link™ Coupler
Release Button
Guide Recess
Knob
Primary Hole
Upper Shaft Housing
90˚ Edge
Trimming Hole
EZ-Link™ Coupler
2.
While firmly holding the add-on, push it straight into the
EZ-Link™ coupler (Fig. 7).
NOTE: Aligning the release button with the guide recess will
help installation (Fig. 6).
3.
Turn the knob clockwise to tighten (Fig. 8).
Fig. 7
Fig. 8
Knob
Lower Shaft Housing
Release Button
ASSEMBLY INSTRUCTIONS
WARNING:
Before you begin using any
attachment, read and understand the manual that
came with the attachment. Follow all safety
information contained within.
WARNING:
To avoid serious personal injury and
damage to the unit, shut the unit off before
removing or installing add-ons.
CAUTION:
The add-ons with the coupler system
are to be used in the primary hole only. Using the
wrong hole could lead to personal injury or damage
to the unit.
CAUTION:
Lock the release button in the
primary hole (Fig. 7) and securely tighten the knob
before operating this unit.
2.
Press and hold the release button (Fig. 6).
3.
While firmly holding the upper shaft housing, pull the
cutting attachment or add-on straight out of the EZ-
Link™ coupler (Fig. 7).
Installing the Cutting Attachment or Add-Ons
NOTE: To make installing or removing the add-on
easier, place the unit on the ground or on a work
bench.
1.
Turn knob counterclockwise to loosen (Fig. 6).