Zanussi ZDC37100W - Manual (Page 15)

15
operation.
Proceed as follows:
• Open the small door at the lower
part of the cabinet
• Turn the yellow stop upwards
• Pull out the reservoir
• Open the small cover and let water
flow down
• Close the small cover and re-insert
correctly the reservoir
• Push it until it clicks and turn the
yellow stop downwards to firmly
lock it.
• Close the small door and press the
Empty tank button again to allow
the programme to continue.
The reservoir must be re-insert-
ed correctly.
If this is not done the pilot light Empty
tank comes on during next drying and
the programme stops, leaving the
laundry damp. The buzzer will sound for
1 minute.
After emptying and inserting the
reservoir the Start/Pause button has to
be depressed again to allow the
programme to continue.
Handy tip: The condensed water may
be used in a steam iron or to top up a
battery, etc. In this case it must be
filtered (e.g. through a coffee filter).
Cleaning the air intake grille
Using a vacuum cleaner remove the
fluff from the air intake grille at the
back of the appliance.
Cleaning the drum
When your laundry does not reach the
desired degree of dryness, in other
words, when it turns out either too dry
or too damp, we advise you to clean
the inside of the drum with a cloth
soaked with vinegar. This will eliminate
the slight patina that has formed in the
drum (due to residues of detergent and
softeners used in the washing, and to
the lime contained in the water), which
prevents the probes from detecting the
correct degree of dryness.
P1203