Xyron 850 - Manual (Page 2)

Parts and Functions
Document Feed Tray
Used to guide document into dispenser. Leading
edge of document slides in between tray and
paddle during insertion. Align to right for A3/A4
documents, to the left for letter documents.
Document Feed
Paddle
Helps ensure
wrinkle-free output
by providing slight
back-tension on
document.
Roller
Springs
Provide spring
force on rollers.
Remove
springs to
remove rollers
and cut-blade.
Cut Blade
Slides to the left and right to cut output
material after it exits dispenser. Also
can be used to trim excess material
from leading edge of document.
Setting Up
Remove the Xyron System and Document Feed Tray from the packaging. The System is shipped with a sample
supply cartridge already installed. Install the feed tray by inserting it horizontally into the cartridge opening by the
grooves in the left and right dispenser side plates as shown below. When correctly
installed, the tray will rest horizontally.
Lower groove in
dispenser side plates
Upper groove
in dispenser
side plates
Basic operation
Step 1 - Insert and align document on feed tray.
Extend the document completely into the cartridge
opening. Align to the left for letter size documents,
to the right for A3/A4 documents.
Document
Feed Tray
Assembly
Cartridge
(reference)
Step 2 - Gently guide the document forward while
turning the handle clockwise.
Step 3 - Trim to desired length using the cut blade
at the roller exit. Apply pressure down on the
orange blade holder and slide to the left or right.
Replaceable
Supply Cartridge
Holds various lengths and
combinations of film and
adhesive depending upon
application.
Handle
Used to advance
cartridge supplies
when rotated
clockwise. Also,
feeds document
through dispenser.
Document
Output
Location where
document exits
dispenser when
handle is rotated
clockwise.
GB