Yard-Man 31AE993I401 - Manual (Page 15)

15
Figure 16
• Remove the six carriage bolts (three per side),
belleville washers and hex nuts which attach skid
shoes to the snow thrower on two sides. See Figure
11.
• Reassemble new skid shoes with the hardware
removed earlier (cupped side of belleville washer
against the skid shoes). Make certain the skid
shoes are adjusted to be level.
• To remove the shave plate, carriage bolts, belleville
washers and hex nuts which attach shave plate to
the snow thrower housing. For location of shave
plate and carriage bolts, see Figure 16.
• Reassemble the new shave plate, making sure
heads of carriage bolts are to the inside of the
housing.
Replacing Belts
To remove and replace either the auger belt or the drive
belt, follow the steps below and then proceed to the
specific steps listed under respective sub-headings.
• Disconnect the chute crank assembly at the
discharge chute end by removing the hairpin clip
and the two flat washers.
• Remove the plastic belt cover, located near the
engine, by removing the three self-tapping screws
and flat washers that secure it. See Figure 17.
• Remove the large shoulder bolt and washer on the
left hand side of the engine pulley. See Figure 17.
Figure 17
Auger Belt
• Remove the cotter pin and washer from the ferrule
in order to disconnect the auger idler rod from the
brake bracket assembly. See Figure 18.
• Slip the auger control belt (the front belt) off the
engine pulley.
Figure 18
Shear Bolts
Carriage Bolt
Hex Nut
Washer
Shave Plate
Upper Bolt
(remove)
Hairpin
Clip
Flat
Belt Cover
Belt Cover Bolts(3)
Shoulder Bolt
(do not remove)
Washers
Shoulder Bolt
Engine Pulley
Ferrule
Engine
Pulley
Auger Idler
Rod
Auger Control
Belt
Brake Bracket
Assembly
Z Fitting
Cable Roller
Guide