Yamaha GX-500VCD - Manual (Page 12)

E-4
Preparations and connections
Installing batteries in the remote control
Notes
● The area between the remote control and the main unit must
be clear of large obstacles.
● Do not expose the remote control sensor to strong lighting,
in particular, an inverter type fluorescent lamp. Otherwise,
the remote control may not work properly. If necessary,
position the main unit away from direct lighting.
Battery replacement
If you find that the remote control must be used closer to the
main unit, the batteries are weak. Replace both batteries with
new ones.
Remote control operation range
2
1
3
SET MD
REC/PAUSE
TAPE
DISC 1 DISC 2 DISC 3
3–DISC VCD CHANGER
DOWN UP VOLUME
PUSH OPEN
MINI COMPONENT SYSTEM GX–700
MINIDISC RECORDER MD
PRESET/ TUNING/ BAND A/B/C/D/E
DISC CHANGE OPEN / CLOSE
MODE– PTY SEEK– START
30 ° 30
°
Setting the video output format selector (TV MODE) switch
This system is designed for use with the NTSC and PAL
television formats. Set this switch to the position for the format
your TV monitor employs.
PAL: Set to this position if your TV monitor employs the PAL
format.
AUTO: Set to this position if your TV monitor can be switched
in between the PAL and NTSC formats automatically.
NTSC: Set to this position if your TV monitor employs the
NTSC format.
ANTENNA
75 Ω UNBAL.
FM GND AM
TV MODE PAL
NTSC AUTO
OUT
SUBWOOFER
AUX/MD
VIDEO SIGNAL
MONITOR OUT
TV MODE
OUT
SUBWOOFER VIDEO SIGNAL
MONITOR OUT
TV MODE
PAL
NTSC
AUTO
DIGITAL OUT OPTICAL
1. Turn the remote control over and remove the battery
compartment cover by pulling it up while pressing the edge
of the cover in the direction of the mark.
2. Insert the batteries (AA, R6, UM-3 type) according to the
polarity markings on the inside of the battery compartment.
3 . Attach the battery compartment cover.
Notes
● Remove the batteries if the remote control is not used for an
extended period of time.
●
If batteries leak, dispose of them immediately. Avoid
touching the leaked material and contact with clothing, etc.
Clean the battery compartment thoroughly before installing
new batteries.
● Be sure to use the same type of batteries together.
● Do not use a new battery and an old battery together.
(Singapore model)
0.2 m – 6 m
(8” –20’)