Xerox 701P28020 - Manual (Page 60)

X e r o x N u v e r a P a p e r G u i d e B - 4
P r i n t i n g w i t h t a b s
For systems with a Multi-Function Finisher (MFF)
• Use only reverse collated tabs.
• Load tabs with the last tab in a set on top. For 5-bank tabs,
load tabs 5, 4, 3, 2, 1 - with 5 on top.
• Load paper according to the labels on the feed trays with the
tabs on the trail edge.
• Program the feed trays.
• Program the job to run N-1, face-up.
• If printing on 8.5 x 11 inch tabs, set the properties for the tabs
as single-sided Exception Pages and set the image shift to 1/2
inch.
• If using preprinted tabs, add them as Inserts.
• If the job uses hole punched tabs and hole punched body
stock, both stocks are loaded with the punched edges leading.
• The system assumes that tabs are right edge portrait or
bottom edge landscape. If the job is different, you may need to
select [Rotate 180] for the entire job.
• If using Build Job to program the tab job, select [Build Job
Type: Contains Tab Stock or Envelopes].
• Tabs cannot be loaded in the Insertion Module.
For systems with FTM / DS5000 or BFM type finishers
• Use only forward collated tabs.
• Load tabs with the first tab in a set on top. For 5-bank tabs,
loads tabs 1, 2, 3, 4, 5, with 1 on top.
• Load paper according to the labels on the feed trays with tabs
on the trail edge.
• Program the feed trays.
• Program the job to run 1-N, face-down.
• If printing on 8.5 x 11 inch tabs, set the properties for the tabs
as single-sided Exception Pages and set the image shift to 1/2
inch.
• If using preprinted tabs, add them as Inserts.
• If the job uses hole punched tabs and hole punched body
stock, both stocks are loaded with the punched edges leading.
• The system assumes that tabs are right edge portrait or
bottom edge landscape. If the job is different, you may need to
select [Rotate 180] for the entire job.
• If using Build Job to program the tab job, select [Build Job
Type: Contains Tab Stock or Envelopes].
• Tabs can be loaded in the Insertion Module.