Yamakawa LM-17W / LT-17W - Manual (Page 9)

6
Enter a standby status
1、Press key POWER, the unit will enter a standby status and the indicator light will turn
red at the same time.
2、Press key POWER again, the unit will exit the standby status and the indicator light will
turn orange( no signal inputting ) or green(signal inputting).
Select the TV channel you want
You can use Channel Select on the remote control to select TV channels
directly.
The unit can store 199 channels （1 to 199）, and you can press the keys on
the remote control or on the panel to make a selection.
1、Press the relevant key on the remote control if you want
to choose any channel from 0 to 9.（for example: if you
want to choose channel 8, just press the key number 8.）
2、If you want to choose a channel bigger than 9, please
press key -/-- at first, and then press the number you want.
（ for example: select channel 45）
（ 1）、Press key -/--；
（ 2）、Press key number 4；
（ 3）、Press key number 5。
note
· Use the second way to select a channel, you should finish all steps in 4
seconds.
· Use key -/-- to switch between stations 0~9 and 10~199.
3.Auto search TV proglams
(surely that you have Used key INPUT to set the video input mode to TV model)
You can press key menu on the remote control and use key CH+ or CH- select
Auto Scan, then press key VOL+ begin to search the TV proglams.
When you want to stop the search ,you can press key VOL-.
Use key CH （ ）/（ ）on the remote control the panel to select the channel you want.
Press key CH （ ）, and the channel will be changed as follows:
2→3→…→198→199→1→2→3…
Press key CH （ ）, and the channel will be changed as follows:
3→2→1→199→198→…→4→3