Zebra Technologies S-300 - Manual (Page 54)

Media Specifications
Total media width Maximum 4.5" 115 mm
Maximum with cutter installed 4.0" 101.6 mm
Minimum 0.75" 19 mm
Label length Maximum See “Printing Considerations” (page 45)
Minimum Tear-Off 0.63" 16 mm
Peel-Off 1.00" 25.4 mm
Cutter 1.50" 38.1 mm
Total thickness
(includes liner)
Maximum (Printhead position
may need to be adjusted above
0.01")
0.012" 0.304 mm
Minimum 0.003" 0.076 mm
Core size 3.0" 76.2 mm
Maximum roll diameter 8.0" 203.2 mm
Inter-label gap Maximum 0.157" 4 mm
Minimum 0.079" (0.118" preferred) 2 mm (3 mm preferred)
Ticket/tag notch size 0.236" W x 0.079" L 6 mm W x 2 mm L
Ribbon Specifications
Ribbon Width Zebra recommends using ribbon at least as
wide as the media to protect the printhead from wear.
Minimum 1.57" 40 mm
Maximum 4.3" 110 mm
Standard
Lengths
2:1 media to ribbon roll ratio 984’ 300 m
3:1 media to ribbon roll ratio 1476’ 450 m
Ribbon core inside diameter 1.0" 25.6 mm
Maximum ribbon roll diameter 3.20" 81.3 mm
Media Handling
•
Tear-off mode: Produced in strips
•
Peel-off mode (S-500 only): Dispensed and peeled from the liner
•
Cutter mode (S-500 only): Printed and individually cut
•
Rewind mode: Labels externally rewound (Requires optional rewinder,
not available from Zebra Technologies Corporation)
Operator Controls
•
AC Power ON/OFF Switch
•
PAUSE key - stops and restarts the printing process
•
FEED key - forces the printer to feed one blank label
•
CANCEL key - cancels the printing of label formats sent to the printer
•
MODE key - places the printer in the Configuration Mode
Specifications
46