ZyXEL Communications ZyXEL ZyWALL 2WE - Manual (Page 105)

ZyWALL 2 and ZyWALL 2WE
Remote Node Setup 10-7
Table 10-3 Fields in Menu 11.1 (PPTP Encapsulation)
My IP Addr Enter the IP address of the WAN Ethernet port. 10.0.0.140
My IP Mask Enter the subnet mask of the WAN Ethernet port. 255.255.255.0
Server IP Addr Enter the IP address of the ANT modem. 10.0.0.138
Connection
ID/Name
Enter the connection ID or connection name in the ANT. It must
follow the “c:id” and “n:name” format.
This field is optional and depends on the requirements of your DSL
modem.
N:My ISP
Schedules You can apply up to four schedule sets here. For more details refer
to the Call Schedule Setup chapter.
Nailed-Up
Connections Press [SPACE BAR] and then [ENTER] to select Yes if you want to
make the connection to this remote node a nailed-up connection. No
10.4 Edit IP
Move the cursor to the Edit IP field in menu 11.1, then press [SPACE BAR] to select Yes. Press
[ENTER]
to open Menu 11.3 - Network Layer Options.
Figure 10-5 Menu 11.3: Remote Node Network Layer Options for Ethernet Encapsulation
This menu displays the My WAN Addr field for PPPoE and PPTP encapsulations and Gateway IP
Addr field for Ethernet encapsulation.
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
Network Address Translation= SUA Only
Metric= N/A
Private= N/A
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL: