Zanussi ZWQ 5122 - Manual (Page 11)

Unpacking
2
1
1
2
2
1
Untying
A B
D
C
A
1
2
B
2
1 B
D
Keep the transit bolts for
when you move the appli-
ance.
To install the appliance at
the same level as neigh-
boring furniture, cut these
plastic pieces.
Water supply
90 O 90 O 90 O
In case of necessity move
the inlet hose in the direc-
tion shown on picture. To
make this loose the inlet
hose ring nut and position
the inlet hose downwards
as drawn on picture.
Tighten the ring nut back
and make sure there are
no leaks.
Open the water inlet tap.
Check there are no leaks.
The water inlet hose can
not be extended. If it is too
short, please contact the
after-sales service.
Drainage
Fit the U-piece on the drain-
age hose. Place everything
in a drainage point (or in a
sink) at a height of between
70 and 100 cm. Ensure it is
positioned securely. Air
must be able to enter the end
of the hose, to avoid any risk
of siphoning.
The drain hose must never be stretched. If it is too short,
contact an engineer.
Electrical connection
This washing machine must only be connected in single-
phased 230 V. Check the fuse size: 13 A for 230 V. The
appliance must not be connected with an extension lead
or multi-plug adaptor. Ensure that the plug is earthed and
that it is in accordance with current regulations.
Positioning
Position the appliance on a flat and hard surface in a ven-
tilated location. Ensure the appliance does not come into
contact with the wall or other furniture. Accurate levelling
avoids vibrations, noise and prevents the appliance from
moving when running.
max
100 cm
min
70 cm
11