ZTE ZXDSL 831 - Manual (Page 16)

ZXDSL 831/831B/831II/831BII User’s Manual
11
using the RJ-11 telephone cable, connect the phone set lines to the PHONE
interface of the splitter, and then connect the user telephone cable port to the
LINE interface of the splitter.
4 Connect the power
Connect one terminal of the power adapter to the PWR interface of the
ZXDSL 831/831B/831II/831BII, and the other terminal to the socket on the
wall, and then switch on the power of the ZXDSL 831/831B/831II/831BII
equipment.
Checking all connection cables
Check all connection cables following the below procedure.
1 Check the ADSL cable connection
If the DSL LED is on upon power-on of the ZXDSL 831/831B/831II/831BII,
it indicates that the ADSL line is correctly connected (Generally it takes one
to two minutes to perform the ADSL connection).
2 Check the computer connection
If both the LINK LED on the computer adapter and the Ethernet LED of the
ZXDSL 831/831B/831II/831BII turn green, it indicates that the computer
and the ZXDSL 831/831B/831II/831BII equipment are correctly connected.
3 Check the telephone cable connection
The telephone cable is correctly connected if the received telephone signals
are normal and free of noise. And the telephone will not be affected no
matter whether the ZXDSL 831/831B/831II/831BII is powered on or off.