Yard-Man YM25 - Manual (Page 13)

13
SECTION 7: MAINTENANCE AND REPAIR INSTRUCTIONS
Line Locking Hole
Trimming Line
Line Loading Hole
Eyelet
5. Insert the line into the locking hole. Do not push the
line more than a 1/2 inch (12.7 mm) into the line
locking hole. The line will form a small loop when it is
inserted correctly. See Figure 17.
3. Pull old line out of the line loading and line locking
holes. See Figure 16 and 17.
4. Insert a piece of trimming line straight into one of the
two eyelets in the outer spool. Push it up through the
line loading hole in the inner reel. See Figure 16. Do
not bend the line when inserting it into the eyelet.
6. Pull the line from the outer spool until the line is tight
against the inner reel. See Figure 18.
Installing a Pre-wound Reel
1. Turn the bump knob counterclockwise and remove
the bump knob, spring and foam seal. See Figure 21.
9. If winding the line becomes difficult or if the line
jams, pull the ends of the line from the spool. See
Figure 20. Continue winding the inner reel
counterclockwise.
7. Repeat procedures 4-6 with the second piece of line.
8. Hold the outer spool. Wind the inner reel
counterclockwise until approximately four (4) inches
(102 mm) of line remain. See Figure 19.
NOTE: Do not wind the inner reel before installing the
second piece of line.
Bump Knob
Foam Seal
Spring
Inner Reel
Figure 21
Figure 20
Figure 19
Figure 18
Figure 17
Figure 16