Zanussi TSE 1062 V - Manual (Page 13)

13
B. FOR THE INSTALLER
1. WARNINGS
• This washing machine is heavy. Take care when
moving it.
• You must remove the packing on the washing machine
before use. Failure to remove all transport protection
devices can cause damage to the washing machine or
nearby furniture. The washing machine must be
unplugged while packing is being removed.
• Do not allow any one other than a qualified plumber to
make the hydraulic connections necessary to install
your washing machine.
• The washing machine must be plugged in to a power
outlet with a conform earth.
• Call a qualified electrician if the electrical installation in
your residence is such that you have to modify it before
you can connect your washing machine.
• Please read the instructions in the "electrical connec-
tions" chapter carefully before connecting your
washing machine.
• After installing your washing machine, make sure that
it is not standing on its electrical power supply cable.
• When your machine is installed on a carpeted floor,
make sure that the carpet does not close off the venti-
lation openings near the bottom of the machine.
• The power supply cable may be only replaced by the
After Sales Service.
• Your manufacturer cannot be held responsible for any
damage resulting from a nonconform installation.
2. TECHNICAL CHARACTERISTICS
DIMENSIONS Height
Width
Depth
850 mm
400 mm
600 mm
VOLTAGE / FREQUENCY
TOTAL POWER 230 V / 50 Hz
2300 W
WATER PRESSURE
Connection to the water network
Minimum
Maximum 0,05 MPa (0,5 bar)
0,8 MPa (8 bars)
Type 20x27
This washing machine complies with CEE directive 89-336 about the limitation of radioelectric disturbances
and directive CEE 73-23 for electrical safety.