Xantech AM/FM Radio Tuner - Manual (Page 7)

7
Note:
To simplify explanations, instructions refer to names of buttons and controls on
the front panel, making no mention of the use of remote control unit.
The equipment draws nominal non-operating power from the AC outlet with
its POWER switch in the OFF position.
REMOTE SENSOR
When operating the remote control unit, point it towards the REMOTE SENSOR.
STANDBY indicator
This indicator lights when the unit is in the standby mode.
When the unit is turned on, it goes off.
POWER switch
Press this switch to turn the unit on or off.
FM button, AM button
Use these buttons to select FM or AM.
FM MODE button
Use this button to select stereo or monaural.
PRESET button
Use this button to select the preset tuning mode.
DIRECT button
Use this button to select the manual tuning mode.
You can use the numeric buttons to directly input frequency numbers.
MEMORY button
Use this button to store preset channels into memory.
TUNING/PRESET buttons
Use these buttons to tune in a station.
Numeric buttons
These buttons are used either to input frequency numbers or to select preset
stations.
Display K
J
I
H
G
F
E
D
C
B
A