Yamaha Professional Audio Workstation AW4416 - Manual (Page 304)

SET UP screen
16
— Reference Guide
Patch OUT page
Patch signals to output jacks
[Function]
Assign output signals to the OMNI
OUT jacks, STEREO OUT jacks,
DIGITAL STEREO OUT jack, and
the output channels of I/O cards.
[Key operations]
• [SETUP] key → [F2] (Patch OUT)
key
(*1)
• Repeatedly press the [SETUP]
key until the display shown at
right appears.
*1. In the SET UP screen, the tabs
displayed at the bottom of the
screen are divided into two
groups. If the Patch OUT tab is
not assigned to the [F2] key
when you press the [SETUP]
key, press [SHIFT] key + [F1]
(CHANGE TAB) key to switch
the tabs.
[Mouse operation]
M button → SETU button → Patch OUT tab
[Screen functions]
A OMNI OUT ASSIGN
Select the signals that will be output from the
OMNI OUT 1–4 jacks. The following signals
can be assigned.
B D.ST OUT ASSIGN (digital stereo out
assign)
C ST OUT ASSIGN (stereo out assign)
These respectively select the pair of signals that
will be output from the DIGITAL STEREO OUT
jack and the STEREO OUT jack. The following
signals can be assigned.
3
1
2
4
Display Signal type
AUX 1–AUX 8 AUX buses 1–8
RDR 1–RDR16
Recorder direct outputs 1–
16
ST L/ST R
L/R channels of the stereo
output channel
Display Signal type
ST L/R Stereo output channel
BUS 1/2–BUS 7/8 Bus 1/2–7/8
DIR 1/2–DIR15/16
Input channel direct out 1/
2–15/16
AUX 1/2–AUX 7/8 AUX buses 1/2–7/8
RDR 1/2–RDR15/
16 Recorder direct outs 1/2–
15/16