Zebra Technologies EM 220 - Manual (Page 16)

Rev. 1.00 - 16 -
EM 220
Mobile Printer User’s Manual
3. Installation & Usage
3-1 Battery Installation
1) Insert the battery on the rear side of the
printer, aligning the battery hook properly.
2) Push the battery into the slot until a
snapping sound is heard.
NOTE
As the battery is not charged at the time of
purchase, charge the battery prior to product use.
(Use the battery charger and/or the optional
battery holder.)
3-2 Battery Charging
3-2-1 Battery Charging Usage
1) Turn off the printer power.
2) Connect the power cord② to the battery
charger ①.
3) Open the Interface Cap ③.
4) Connect the battery charger ① to the
power connector of the printer.
5) Plug the power cord ② into an electrical
outlet.
CAUTION
The printer may incur serious damage if the battery
charger provided by Zebra is not used. Zebra is not
legally liable for any such damages. (The voltage and
electrical current specifications of the printer and battery
charger must match.)
3-2-2 Battery Holder (Optional) Usage
1) Connect the power cord to the battery ②
charger . ①
2) Connect the battery charger to the ①
power connector of the battery holder . ③
3) Plug the power cord into an electrical ②
outlet.
4) Insert the battery into the battery ④
holder until a snapping sound is ③
heard.
①
②
③
④
①
②
③