Yamaha htr-5890 - Manual (Page 20)

16
SPEAKER SETUP
■ FRONT terminals
Connect one or two speaker systems to these terminals. If
you use only one speaker system, connect it to either the
FRONT A or B terminals.
The Canada model cannot output to two separate speaker systems
simultaneously.
Bi-wired connection
The unit also allows you to make bi-wired connections to
one speaker system. Use two pairs of speaker cables for
each speaker (one pair for the woofer and one pair for the
tweeter/mid-range). To use the bi-wired connections, press
SPEAKERS A and SPEAKERS B on the front panel so
that both SP A and B light up in the front panel display.
■ CENTER terminals
Connect a center speaker to these terminals.
■ SURROUND terminals
Connect surround speakers to these terminals.
■ SUBWOOFER jack
Connect a subwoofer with a built-in amplifier, such as the
YAMAHA Active Servo Processing Subwoofer System,
to this jack.
■ SURROUND BACK terminals
Connect surround back speakers to these terminals. If you
only connect one surround back speaker, connect it to the
left (L) terminals.
■ PRESENCE terminals
Connect presence speakers to these terminals.
y
• You can specify the location of speakers connected to the
SPEAKERS B terminals in the SP B menu of the SET MENU
mode (See page 64).
• You can select how the volume control operate with regard to
the ZONE 2 OUTPUT and ZONE 3 OUT PUT in the ZONE 2
SET and ZONE 3 SET menus of the SET MENU mode (See
page 64).
• You can select how the ZONE 2 will be amplified in the ZONE
2 AMP menu of the SET MENU mode (See page 64).
Note
Bi-wired connection
FRONT
R L + –
+ –
+
+
–
–
A
B
This unit
01EN00_HTR5890U.book Page 16 Thursday, December 23, 2004 12:39 PM