Routine charging, Sealed vrla batteries, Caution – Yuasa Battery YUMICRON YUA00ACC05 User Manual

Page 34

Advertising
background image

The single most important thing to maintaining a sealed
VRLA battery is don’t let it sit discharged:
keep it fully charged.

A sealed VRLA motorcycle

battery should be kept to near fully charged for peak
performance. In fact, it can need charging more often
than a car battery because it’s probably not used routinely
and, therefore, not “automatically” charged.

Use the following guidelines for boost charge. Always
verify battery condition before charging, and 30 minutes
after charging.

A fully charged battery should read 12.8v or higher after
battery has been off the charger 1 - 2 hours.

Routine Charging

OVERCHARGING CAN HARM YOUR BATTERY BEYOND
RECOVERY.

A word on overcharging: don’t. Because of the charac-
teristics of a sealed VRLA battery, too much of a boost
charge will decrease the volume of electrolyte. The
longer the overcharge time, the greater the drop in elec-
trolyte – and starting power.

Water can’t be added to the sealed VRLA battery to make up
the difference. Overcharging can warp plates, making
future charging difficult or impossible. Watch charging times
carefully, or ideally, use a Yuasa Automatic Charger. Always
stop charging if the battery becomes really warm to the
touch. Let it cool down 6 - 12 hours and resume charging.

32

Caution:

Always wear safety glasses and charge in a ventilated area. If battery gets really warm to the touch, discontinue

charging and allow battery to cool down. No sparks, flames or smoking when charging.

State

Charge Time

*

of

Voltage

Action

(Using a constant

Charge

current charger

@ std. amps specified

on the battery)

100%

12.8v - 13.0v

None

Check at 3 months

None Required

from date of
manufacture

75% -100%

12.5v - 12.8v

May need slight

charge, if no

3 - 6 hours

charge given,

check in 3 months

50% - 75%

12.0v - 12.5v

Needs charge

5 - 11 hours

25% - 50%

11.5v - 12.0v

Needs charge

At least 13 hours

verify state

of charge

0% - 25%

11.5v or less

Needs charge

20 hours

(see special instructions

on page 33)

*

Charging times can vary depending on type of charger. Follow the charger’s instructions.

5

SECTION

Sealed VRLA
Batteries

Advertising