Zenoah PE2500H - Manual (Page 13)

7. Operation
■ STARTING ENGINE
1. Push a priming pump at lower side of the
carburetor several times until you can see the
fuel flows into a clear tube. (F3)
2. Put the choke lever to CLOSE position, and set
the throttle lever 1/3 to 1/2 open from fully
returned position. (F3)
Choke lever to OPEN for restarting immediately
after stopping engine.
3. Confirm that the machine is stable on the
ground. While holding the plug guard with your
left hand, pull the starter knob with right hand.
Starter knob shall be initially pulled gently, then
vigorously when you feel resistance. (F4)
Avoid pulling out entire length of the rope or free
returning of rope by releasing the knob. Doing this
may cause starter failure.
In case the engine does not start due to excess
fuel, fully open the choke and throttle levers and
repeat pulling the rope. Or take out the spark plug
to dry and repeat the procedure.
4. When the engine is started, gradually open the
choke lever, also return the throttle lever, and
allow the engine 2 to 3 minutes of warming up at
a low speed.
5. Operate the engine at a half throttle until the
water in suction hose reaches the pump. As
water discharge is started, adjust the throttle
according to your required flow rate within the
capacity.
NOTE
IMPORTANT
NOTE
❲ 13 ❳
F3
F4