Zanussi TDE 4224 W - Manual (Page 6)

6
1 2 3 4 5 6 11
7 9
8 10
START BUZZER
OFF
ON-OFF
ELECTRONIC SENSOR
A U T O R E V E R S E
COTTON SYNTHETICS
TDE 4224 W
F
EXTRA DRY
G
STORE DRY
H
LIGHTLY DAMP
A
EXTRA DRY
B
STORE DRY
C
LIGHTLY DAMP
D
IRON DRY
E
MACHINE IRON DRY
LOW
TEMP.
SELECTOR X TRA C APACITY X TRA C APACITY IMPORTANT: PLEASE READ THE INSTRUCTION BOOK BEFORE USING THIS APPLIANCE
The Control Panel
1 Programme Chart
This will help you to select the correct programme
for drying.
2 Mains-On Light
It comes on when the appliance is switched on (ON-
OFF button pressed down) and goes out when this
button is released.
3 ON-OFF Button
This button is used to switch the dryer on. At the end
of the programme, release this button by pressing it
again to switch the dryer off.
4 Low Temperature Button
Pressing this button allows drying to be performed at
a lower temperature, for delicate items.
The corresponding pilot light comes on.
5 Buzzer OFF Button
A buzzer sounds during the anti-creasing phase.
Press this button when selecting the programme if
you wish to switch the buzzer off.
The corresponding light illuminates.
6 Start Button
Press this button for about 2 seconds to start the dryer
after having selected the drying programme.
If the door is opened while the programme is
running, this button must be pressed again after
closing the door in order to re-start the
programme from the point at which it was
interrupted.
This button must also be pressed after a power cut.
In both cases light
or (depending on the
phase in progress) flashes to remind you that the start
button needs to be pressed again.
7 “Drying” Light
This light indicates that the machine is performing
the drying phase.
8 “Cooling” Light
This light indicates that the appliance is in the
cooling phase. At the end of drying, there is a 10
minute cooling phase to cool the laundry.
If light
or is flashing, this means that the
Start Button needs to be pressed again for the
programme to resume.
9 “End of Programme” Light
This light flashes at the end of the cooling phase and
during the anti-creasing phase.
10 “Anti-creasing” Light
This light flashes alternately with the light at the
end of the drying phase (after cooling) and during the
anti-creasing phase.
If only light flashes, this means that the anti-
creasing phase has finished.
11 Programme/Time Selector Dial
It allows you to select electronically controlled or
time controlled drying.
Turn the dial to the required programme or time.
125994630.qxd 02/05/01 11.03 Pagina 6 (Nero/Process Black pellicola)