Yamaha DSP -A780 User Manual
Page 19
5
PRO LOGIC Indicator
Illuminates while the built-in Dolby Pro Logic Surround Decoder is
being activated.
6
DSP Indicator
Illuminates while the built-in Sound Field Processor is being
activated.
7
Input Selector Switch
Sequentially selects the input source that you want to listen to
and/or watch in the
ᮤ
ᮤ
or
ᮣ
ᮣ
direction. The indicator
corresponding to the selected input source illuminates. The
selected input source is also shown by the display panel and
the monitor screen (When the monitor is on).
8
Input Selector Switches for VCR 1, CD and LD
Directly selects VCR 1, CD or LD as the input source.
9
Phones Jack
Plug in headphones here for private listening. If the Center
Mode is set to “PHNTM” (phantom), the center channel will be
heard along with the main channels. (See page 22.) Otherwise
the main channels only will be heard.
0
Auxiliary Input Jacks (AUX 2)
Connect an auxiliary video or audio input source equipment
such as a camcorder to these jacks. If the connected video
equipment has a S video output terminal, connect it to the S
VIDEO jack to obtain a high resolution picture. The source
connected to these jacks can be selected by the input selector
switch.
A
Rec Out Switch
Used to select the source to be recorded to tape deck or VCR
independent of the selection of input source. When pressed,
the indicator corresponding to the currently selected source to
be recorded flashes. While an indicator is flashing, you can
change the selection of the source to be recorded with the
input selector switches. The selected source is also shown by
the display panel and the monitor screen (when the monitor is
on).
B
Bass and Treble Controls
Adjust the sound to match your tastes. Can also be used to
compensate for room acoustics. Defeated in the center
position.
C
Program Selector
Sequentially selects the digital sound field processing
programs in the + or – direction.
D
Balance Control
Adjusts the left and right output volume to the Main Speakers
to compensate for sound imbalance caused by speaker
positions or listening room conditions.
E
Effect Switch
Normally ON, this switch can be turned OFF to disable output
from the center and effect speakers so that the sound
becomes normal 2-channel stereo.
F
Master Volume Control
Simultaneously controls signal level at all outputs: main, rear
effect, center, and subwoofer. (This does not affect TAPE REC
OUT level.)
17