Workstation setup, Test print – Xerox WorkCentrePro User Manual
Page 70
5 EtherTalk
70
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 System Administration Guide
NOTE: If you do not wish to use the IP filter feature, select [Off].
NOTE: Use CentreWare Internet Services to register the IP addresses which are not
allowed to access the machine. Refer to the CentreWare Internet Services chapter of
the User Guide.
14.
When you have finished establishing TCP/IP, select [Close] from the [Protocol
Settings] screen.
Workstation Setup
Install the print driver (Adobe PS) for Macintosh. Install the screen font if necessary.
Refer to the PostScript User Guide.
Test Print
To make sure that the machine has been installed on the network correctly a test print
should be submitted from a client workstation. Perform the following steps.
1.
Open a sample document on a client workstation.
2.
Select the machine using the Chooser (Mac OS 7.5 or later, 8.x, or 9.x) or the
Print Center (Mac OS X 10.2).
3.
Print the document on the machine and verify that it prints correctly.
4.
Make sure that the driver is installed on every workstation that will be sending jobs
to the machine.
5.
Repeat the test for all workstations that will be sending jobs to the machine.
The installation process is now complete.
If the test print fails, refer to Problem Solving chapter for assistance.