Zanussi ZGF 647 - Manual (Page 4)

4
1.Instruction for the User
HOB BURNERS CONTROL KNOBS
The hob burners control knobs are situated on the hob
lateral panel. The symbols on the knobs mean that :
l there is no gas supply
there is maximum gas supply
there is minimum gas supply
LIGHTING THE BURNERS
• For easier lighting, proceed before putting a pan
on the pan support.
To light a burner, push in the relevant control knob and
turn it anti-clockwise to "maximum" position.
Upon ignition, keep the knob pushed down for about 5
seconds. This will allow the "thermocouple" (Fig. 1 lett.
D) to be heated and the safety device to be switched
off, otherwise the gas supply would be interrupted.
Then, check the flame is regular and adjust it as
required.
If you cannot light the flame even after several
attempts, check the "cap" (Fig. 1 lett. A) and the
"crown" (Fig. 1 lett. B) are in the correct position.
To put the flame out, turn the knob to the symbol l.
• Always turn the flame down or put it out before
taking the pans off the burner.
USING THE HOB CORRECTLY
To ensure maximum burner efficiency, it is strongly
recommended that you use only pots and pans with a flat
bottom fitting the size of the burner used, so that flame will
not spread beyond the bottom of the vessel (see the table
beside).
It is also advisable, as soon as a liquid starts boiling, to
turn down the flame so that it will barely keep the liquid
simmering.
Carefully supervise cookings with fats or oil, since
these types of foodstuff can result in a fire, if over-
heated.
Burner minimum maximum
diameter diameter
Big (rapid) 180 mm. 260 mm.
Medium (semirapid) 120 mm. 220 mm.
Small (Auxiliary) 80 mm. 160 mm.
Fig. 1
Contents
FO 0204
1. Instruction for the User ............ Pag. 4
2. Cleaning and Maintenance ...... Pag. 5
3. Periodic Maintenance ............... Pag. 5
4. Maintenance -
Technical assistance.................. Pag. 5
5. Technical Data........................... Pag. 6
6. Instruction for the Installer ...... Pag. 6
7. Electrical Connection ............... Pag. 7
8. Adaptation to different
types of gas................................ Pag. 8
9. Building In .................................. Pag. 10