Xerox 4110 - Manual (Page 14)

Xerox 4590 EPS/4110 EPS System Administration Guide 2-2
2. Installation
KEY POINT:
For details on setting up the connection between the
client workstation and DocuSP Controller, refer to the DocuSP
Controller customer documentation.
Installing the network cable
This section describes the installation procedure for the network
Ethernet connection. The Ethernet interface supports the following
types of connectors:
•
10/100/1000Base-T
• CAT5
1. Confirm that the power switch is turned off.
2. Connect a network cable to the Ethernet interface connector.
NOTE: Prepare a network cable suitable for your network
connection. When changing the network cable, consult the
appropriate personnel.
3. Switch on the machine.