Zanussi FLS 1183 W - Manual (Page 6)

1 Programme guide
2 Half load button
Select this button to reduce water consumption on the
rinse cycle when washing a half load of cottons or linens
(maximum load size = 2.25 kg).
The machine will perform 3 rinses instead of 4.
3 Rinse Hold button
Press this button to make the machine stop with water in
the drum after the synthetic or delicate wash cycles.
This prevents any creasing which may occur if the
clothes are left damp in the drum. When it is convenient
for you to empty the machine, simply press this button
again so that the machine can proceed to drain and spin,
or turn the dial to the drain programme “P”.
If this button is not activated, the washing programmes
will end with a short spin.
Do not press this button for woollens: wool items should
be gently spun.
4 Spin Speed Reduction button
By depressing this button the spin speed will be reduced
as follows:
- cotton and linen: from 1050 to 500 rpm
- synthetics, delicates and wool: from 600 to 400 rpm.
6
The Control Panel
500 rpm RINSE
H O L D
HALF
LOAD
1 1 8 3 W F L S
ECONOMY
1 0 5 0
Whites + Prewash
Whites
Fast coloureds
Non-fast coloureds
Hand rinses
Spin 1050 A
B
C
D
F
G Mixed fabrics
Wool care
Delicates
Worn once
Freshen up
Spin 600
Drain H
J
K
L
M
N
P
A Q U A C Y C L E W A S H S Y S T E M IMPORTANT : PLEASE READ THE INSTRUCTION BOOK BEFORE USING THIS APPLIANCE
1 2 3 4 5 6 7
5 Economy button
By depressing this button prior to selecting wash
programmes B, C and H you will obtain a reduction of
the wash temperature from 95°C to 60°C and from
50°/60°C to 40°C . The duration of the programme will
not alter. This will ensure a substantial saving in
electricity consumption. It is advisable to use Economy
when washing fabrics which are lightly soiled.
6 Mains-on light
This light illuminates when the machine starts working
and goes out at the end of the programme.
7 Programme selector dial/ON/OFF
switch
Turn the dial clockwise to select the required wash
programme.
To start the programme, pull the dial outwards.
To switch the machine off, push the dial inwards.
Before setting the dial to any position the machine must
be switched off by pushing the dial inwards.