Zanussi CERAMIC GLASS INDUCTION HOB ZIE6004F - Manual (Page 3)

Installation instructions
Before the installation , note down the serial num-
ber (Ser. Nr.) from the rating plate. The rating
plate of the appliance is on its lower casing.
220-240 V
220-240 V
942 116 604
55 GAD D5 AU
50
ZIE6004F
ZANUSSI
6.9 kW Induction 6.9 kW
Safety instructions
Warning! You must read these!
Make sure that the appliance is not damaged
because of transportation. Do not connect a damaged
appliance. If it is necessary, speak to the supplier.
Only an authorised service technician can install,
connect or repair this appliance. Use only original spare
parts.
Only use built-in appliances after you assemble the
appliance into correct built-in units and work surfaces
that align to the standards.
Do not change the specifications or modify this
product. Risk of injury and damage to the appliance.
Fully obey the laws, ordinances, directives and
standards in force in the country where you use the
appliance (safety regulations, recycling regulations,
electrical safety rules etc.)!
Keep the minimum distances to other appliances and
units!
Install anti-shock protection, for example install the
drawers only with a protective floor directly below the
appliance!
Protect the cut surfaces of the worktop against moisture
with a correct sealant!
Seal the appliance to the work top with no space left
with a correct sealant!
Protect the bottom of the appliance from steam and
moisture, e.g. from a dishwasher or oven!
Do not install the appliance adjacent to doors and
below windows! If not, hot cookware can be hit off the
hob when you open doors or windows.
Warning! Risk of injury from electrical current.
Carefully obey the instructions for electrical
connections.
• The electrical mains terminal is live.
• Make electrical mains terminal free of voltage.
• Install correctly to give anti-shock protection.
• Loose and incorrect plug and socket connections
can make the terminal become too hot.
• A qualified electrician must install the clamping con-
nections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains cable of type H05BB-F Tmax
90°C (or higher) for a single-phase or two-phase con-
nection.
• Replace the damaged mains cable with a special ca-
ble (type H05BB-F Tmax 90°C; or higher). Speak
your local Service Force Centre.
The appliance must have the electrical installation
which lets you disconnect the appliance from the mains
at all poles with a contact opening width of minimum 3
mm.
You must have correct isolation devices: line protecting
cut-outs, fuses (screw type fuses removed from the hold-
er), earth leakage trips and contactors.
3