Yamaha F250 LF250 - Manual (Page 74)

Trouble Recovery
68
EMU29471
Replacing fuse
If a fuse has blown, remove the electrical cov-
er, open the fuse holder and remove the fuse
with a fuse puller (if equipped). Replace it with
a spare one of the proper amperage.
WARNING
EWM00630
Be sure to use the specified fuse. An in-
correct fuse or a piece of wire could allow
excessive current flow. This could cause
electric system damage and a fire hazard.
NOTE:
Consult your Yamaha dealer if the new fuse
immediately blows again.
1. Electrical cover
2. Fuse puller
3. Spare fuse (5 A, 10 A, 15 A, 20 A, 30 A, 80
A)
1. Electric throttle valve / ECM (Electronic con-
trol module) fuse (10 A)
2. Ignition coil / Fuel injector / Variable cam-
shaft timing / ECM (Electronic control mod-
ule) fuse (30 A)
3. Main switch / PTT switch fuse (20 A)
4. Starter relay fuse (30 A)
5. Fuel feed pump fuse (5 A)
6. Fuel pump fuse (15 A)
7. Engine main fuse (80 A)
U6P212E0.book Page 68 Monday, June 6, 2005 4:23 PM