Zanussi IZ10 - Manual (Page 11)

ENGLISH
• Draining and spin:
- Press the START/PAUSE button. The machine
will drain the water, then spin the laundry at the
maximum speed provided for the selected
programme.
- Select spin speed by means of button 5, and
press the START/PAUSE button.
• Drain only
- Press the SKIP/RESET button once , so as to
cause the DRAIN light to light up, then press the
START/PAUSE button.
Important! If you accidentally press the
SKIP/RESET button more than once, the display
will show
three blinking dashes . To drain the
water, select any washing programme by means
of the FABRIC button, then press SKIP/RESET
three times in order to select the DRAIN position
(only the DRAIN light will remain lit).
6 OPTIONS button
Press this button to select the following options:
• PREWASH : select this option if you wish your
laundry to be prewashed before the main wash
(
not available for wool and hand-wash cycle).
The prewash ends with a short spin at 650 rpm in
programmes for cotton and synthetic fabrics,
whereas in the programme for delicate fabrics the
water is only drained.
• SUPER RINSE : this option can be selected with all
programmes except the wool programme and
hand wash. The machine performs 4 rinses
instead of 3. This option is recommended for
people who are allergic to detergents, and in areas
where the water is very soft.
7 TIME SAVE button
This button allows you to select the QUICK WASH
function, for laundry that is only slightly soiled
(not
for wool and HAND WASH programme) .
The washing time will be reduced according to the
type of fabric and the selected temperature.
8 Display
The following pieces of information are shown on the
display:
• Three blinking dashes , when a programme is
cancelled by means of the SKIP/RESET button.
The three blinking dashes will also appear when you
press the ON/OFF button to switch the machine on,
if the previously selected cycle has been erased.
• Duration of washing programme in hours
and minutes, after you have selected a
programme.
While the programme is running (after you have
pressed the START/PAUSE button), the displayed
time value decreases by one unit every minute.
• The washing machine has stopped with water in
the tub , at the end of a programme with the
RINSE HOLD option: this is indicated by a static
zero .
• The washing machine has completed the
programme : this is indicated by a blinking zero .
At the same time, the door locked light goes out.
The zero will reappear when you switch the
washing machine on, unless the previous
programme has been erased by means of the
SKIP/RESET button.
2.05
---
11
132999531-IZ10-IZ12•gb 18-04-2001 11:51 Pagina 11