Yamaha RX-495RDS - Manual (Page 14)

14
BASIC OPERATIONS
TO PLAY A SOURCE
SPEAKERS
A
ON
OFF
B
ON
OFF
TAPE 1 TAPE 2
MONITOR
AUX PHONO
TUNER CD
COPY
TAPE
MONITOR AUX PHONO
TUNER CD
3 1, 6 2
4 7
POWER
RX-495RDS
RX-395, RX-395RDS
1
Set to the “
∞
” position.
2
Turn the power on.
3
Select the desired input source by using the input
selector buttons.
* The name of the selected input source will appear on the
display.
* Note that pressing on each input selector button selects the
source which is connected to the corresponding input
terminals on the rear panel.
4
Select the speakers to be used.
* If you use two speaker systems, press both the A and
B switches.
5
Play the source. (For detailed information on the
tuning operation, refer to page 17.)
6
Adjust to the desired output level.
7
If desired, adjust the BASS, TREBLE, BALANCE and
LOUDNESS controls, etc. (refer to page 16).
Notes
RX-495RDS only
● If you select AUX, TUNER, CD or PHONO, be sure that
TAPE 1 and/or TAPE 2 are not being selected.
● If you select TAPE 1 and TAPE 2 at the same time, the
result will be the sound from the tape deck 1.
● For TAPE 1 and TAPE 2, whenever the button is pressed,
the corresponding input source is selected or canceled
alternately.
RX-395 and RX-395RDS only
● Whenever the TAPE MONITOR is pressed, the tape deck
is selected or canceled alternately.
● If both TAPE MONITOR and another input selector button
are selected, TAPE MONITOR takes priority of another
input selector button.
To turn off the power
Press the POWER switch again.