Yamaha RX-SL80 User Manual
Page 52
48
EDITING SOUND FIELD PARAMETERS
3
Press
/
repeatedly to access the sound
field program parameters.
4
Press / repeatedly to adjust the sound
field parameter.
5
To change parameter values for a different
sound field, repeat steps 2 through 4.
You cannot change parameter values when Memory Guard is set
to “ON”. If you want to change the parameter values, set Memory
Guard to “OFF” (see page 43).
■
DSP LEVEL
Function:
This parameter adjusts the level of all the
DSP effect sounds within a narrow
range.
Description:
Depending on the acoustics of you
listening room, you may want to increase
or decrease the DSP effect level relative
to the level of the direct sound.
Control range:
–6 to +3 dB
■
DELAY
Function:
This parameter changes the apparent
distance from the source sound by
adjusting the delay between the direct
sound and the first reflection heard by
the listener.
Description:
The smaller the value, the closer the
sound source seems to the listener. The
larger the value, the farther it seems. For
a small room, set to a small value. For a
large room, set to a large value.
Control range:
1 to 99 ms
For 5ch Stereo
Function:
These parameter adjusts the volume level
for each channel in 5-channel stereo
mode.
Control Range: 0 to 100%
■
CT LEVEL (Center level)
■
SL LEVEL (Surround left level)
■
SR LEVEL (Surround right level)
For PRO LOGIC II Music
■
PANORAMA
Function:
Extends the front stereo image to include
the surround speakers for wraparound
effect.
Choices:
OFF/ON, initial setting is OFF.
■
DIMENSION
Function:
Gradually adjusts the sound field either
towards the front or towards the rear.
Control range:
–3 (towards the rear) to +3 (towards the
front), initial setting is STD (standard).
■
CT WIDTH (Center width)
Function:
Adjusts the center image from all three
front speakers to varying degrees. A
larger value adjusts the center image
towards the front left and right speakers.
Control range:
0 (center channel sound is output only
from center speaker) to 7 (center channel
sound is output only from front left and
right speakers), initial setting is 3.
Note
ENTER
ENTER