Xyron ProFinishTM Jr. - Manual (Page 3)

2
How to replace the cut blade:
Loosen and remove the screw in the cut bar with wrench. Remove colored
plastic insert and slide the old blade off the cut bar (safely discard old blade).
Carefully slide the NEW ProFinish
™ Jr. blade onto clear bar. NOTE: The sharp
edge of the blade should be facing inward. Replace the colored plastic insert into
clear bar and secure screw with wrench. Verify smooth movement across the
entire length of the clear bar.
Step 1:
Place item flat on the tray, aligned all the way to the left side. Guide the item
forward while slowly turning the handle clockwise.
W W ith just a few simple, easy ith just a few simple, easy - - to to - - follow steps, you’ll be protecting and enhancing follow steps, you’ll be protecting and enhancing
your documents and projects: your documents and projects:
How to replace the cutter assembly:
Align the cutter sides with the machine. Slide in the cutter with the cut bar resting
on the spring arms on the side of the machine until it snaps and locks into place.
Step 2:
After the item is completely visible on the output tray, trim the item by sliding
the blade across the material.
Step 3:
Gently lift up the cutter tray and slide it out. Use the cutter to trim the rest of the
item if necessary. For adhesive, remove the clear mask and peel off the
sticky-back item.
How to load the cartridge:
Open the lid to your ProFinish
™ Jr. machine. Slide the cartridge into the tracks on
the sides of the machine with the exposed rolls of material facing the open lid
cover. Close the lid securely. Advance film and trim.
Getting Started Getting Started