Xerox X2 - Manual (Page 17)

125g/m 2 Presentation Paper – 720dpi 6
Description
A premium quality, medium-weight paper, designed for optimum performance in 720 dpi print mode.
It is specially coated to accept the high level of ink saturation and precise dot placement required for
720 dpi imaging. Use for all high quality presentation applications where sharp lines, crisp text and
maximum colour gamut are required. NOTE: For use with Thermal laminates only.
Applications
Good for all highest quality presentation graphics, such as posters, courtroom graphics, customer,
sales or boardroom presentations, point of sale graphics, framed images, trade show graphics,
museum signage, in-house graphics, merchandising materials, mounted prints, exhibit graphics,
promotional displays, corporate graphics, backlit display, fine art reproductions, photo-realistic
imaging and map reproductions.
Physical Characteristics
Base Weight 125 g/m
2 Indoor Laminated 15 years
Calliper 170 microns Indoor Unlaminated 3 months
Opacity 92% Outdoor Laminated 3 years
Brightness 75 Outdoor Unlaminated Not recommended
Durability
Dimensions
Code Length
023R01363 54” 1372mm 45.7m
023R01364 50” 1270mm 45.7m
023R01365 42” 1067mm 45.7m
023R01181 36” 914mm 65m
Width
Compatibility
Xerox X2
Xerox Xpress
Seiko IP4XXX
Operating Instructions
• Store in a cool, dry environment, free from direct sunlight, within temperatures of 10-35 o C and
non-condensing relative humidity of 30-70%. Store the product in its original carton and
wrapper to protect from dust and moisture. Shelf life is 2 years if kept in original packaging.
• Ensure that roll ends are protected and that the edges of the media are not damaged. If the
media edges are not flat this can result in damage to the printer.
• Keep the image surface dry and free of grease, oil, silicones and dirt. It is recommended that
cotton gloves be used for handling to avoid fingerprints.
• Use within the temperature range 18-30˚C and relative humidity of 40-60%.
• Print in 720 dpi print mode only.
• Laminate only with hot melt laminates if satin or gloss finishes are required, or if protection from
UV, moisture or abrasion is necessary for extra durability.
• Specific settings are required to obtain acceptable laminate adhesion when using some laminates
and laminators. Higher temperature settings and slower speed may be necessary. Refer to the
Lamination Procedures section of this guide for specific settings.
• Take extra care when handling 720 dpi prints after lamination to avoid splitting the laminate
adhesion to the paper. Do not tap edges on tables, counters, etc. Roll images loosely (no smaller
then 3” in diameter).
www.xerox.com/iccprofiles.com
17