Zanussi ZWG 3120 - Manual (Page 17)

Remove the drawer by
pressing the catch down-
wards and by pulling it
out. Flush it out under a
tap, to remove any traces
of accumulated powder.
To aid cleaning, the top
part of the additive com-
partment should be re-
moved.
Cleaning the drawer recess
Having removed the draw-
er, use a small brush to
clean the recess, ensuring
that all washing powder
residue is removed from
the upper and lower part of
the recess.
Replace the drawer and run the rinse programme with-
out any clothes in the drum.
Cleaning the pump
The pump should be inspected if:
• the machine does not empty and/or spin;
• the machine makes an unusual noise during draining
due to objects such as safety pins, coins etc. blocking
the pump.
Proceed as follows:
• disconnect the appliance;
• if necessary wait until the water has cooled down.
Open the pump door.
Place a container close to
the pump to collect any
spillage.
Pull out the emergency
emptying hose, place it in
the container and remove
its cap.
When no more water comes out, unscrew the pump
cover and remove it. Always keep a rag nearby to dry
up spillage of water when removing the cover.
Remove any objects from
the pump impeller by ro-
tating it.
Put the cap back on the
emergency emptying hose
and place the latter back in
its seat.
Screw the pump cover
fully in.
Close the pump door.
Caution! When the appliance is in use and
depending on the programme selected there can be
hot water in the pump.
Never remove the pump cover during a wash cycle, always
wait until the appliance has finished the cycle, and is
empty. When replacing the cover, ensure it is securely re-
tightened so as to stop leaks and young children being
able to remove it.
Cleaning the water inlet filter
If your water is very hard or contains traces of lime deposit,
the water inlet filter may become clogged. It is therefore
a good idea to clean it from time to time.
17