Zanussi ZWS 588 - Manual (Page 18)

Place a bowl with a small
edge close to the pump to
collect any spillage.
Pull out the emergency
emptying cap from the fil-
ter cover, using a pliers.
1
2
When no more water
comes out, unscrew the
pump cover, using a pli-
ers, and remove the filter.
Always keep a rag nearby
to dry up spillage of water
when removing the cover.
Remove any objects from
the pump impeller by ro-
tating it.
Replace the filter into the pump paying attention to in-
sert it properly. When done, screw it firmly.
Replace the emergency
emptying cap into the filter
cover and fix it firmly.
Close the pump door.
Warning! When the appliance is in use and
depending on the programme selected there can be
hot water in the pump. Never remove the pump cover
during a wash cycle, always wait until the appliance has
finished the cycle, and is empty. When replacing the
cover, ensure it is securely re-tightened so as to stop leaks
and young children being able to remove it.
Cleaning the water inlet filters
Important! If the appliance doesn't fill, takes long to fill
with water, the starting button blinks yellow or the display
(if available) shows the relevant alarm (see chapter "What
to do if..." for more details), check if the water inlet filters
are blocked .
To clean the water inlet filters:
• Turn off the water tap.
• Unscrew the hose from
the tap.
• Clean the filter in the
hose with a stiff brush.
• Screw the hose back onto the tap. Make sure the
connection is tight.
18