Yamaha R-V302K - Manual (Page 28)

28
Adjustment of the CENTER LEVEL Adjustment of the REAR LEVEL
If desired, you can adjust the sound output level of the center
speaker even if the output level is already set in “SPEAKER
BALANCE ADJUSTMENT” on page 18.
Note
This adjustment is useful only when the digital sound field
program DOLBY PRO LOGIC or DOLBY 3 STEREO is
selected.
If desired, you can adjust the sound output level of the rear
speakers even if the output level is already set in “SPEAKER
BALANCE ADJUSTMENT” on page 18.
Notes
● If no digital sound field program is used, this adjustment is
useless.
● When the digital sound field program DOLBY 3 STEREO is
selected, this adjustment is useless.
CENTER
LEVEL
0 l0
REAR
LEVEL
0 l0
Adjustment of DELAY TIME
You can adjust the time difference between the beginning of
the sound from the main speakers and the beginning of the
effect sound from the rear speakers.
The larger the value, the later the effect sound is generated.
This adjustment can be made to all programs (except
3
STEREO) individually.
Control range
PRO LOGIC : from 15 to 30 milliseconds
(Preset value: 20 milliseconds)
LIVE HOUSE : from 1 to 100 milliseconds
(Preset value: 20 milliseconds)
HALL : from 1 to 100 milliseconds
(Preset value: 30 milliseconds)
BALLAD : from 1 to 50 milliseconds
(Preset value: 20 milliseconds)
POPS : from 1 to 50 milliseconds
(Preset value: 20 milliseconds)
JAZZ : from 1 to 50 milliseconds
(Preset value: 20 milliseconds)
ROCK : from 1 to 50 milliseconds
(Preset value: 20 milliseconds)
Use the remote control transmitter for adjusting delay
time.
1
Press once or more so that “DELAY” appears on the
display.
2
By continuously pressing the “+” or “–” side of the
TIME/KEY button, the value changes continuously.
The value stops changing momentarily at the preset point.
Note
Adding too much delay will cause an unnatural effect with
some sources.
TIME
/KEY
– +
DELAY
/KEY
Adjustable
ms
ms
Notes
The value of the delay time you set the last time will remain
memorized even when the power of this unit is off.
However, if the power cord is kept disconnected for more than
one week, these values will be automatically changed back to
the original factory settings.