Zanussi ZWH 6105 - Manual (Page 13)

If the pilot light 9 blinks and after a few minutes goes off,
the door can be opened.
If the pilot light 9 remains lit, this means that the machine
is already heating or that the water level is too high. In
any case, do not try to force the door!
If you cannot open the door but you need to open it, you
have to switch the machine off by turning the selector dial
to . After a few minutes the door can be opened
(Pay attention to the water level and temperature!).
After closing the door, it is necessary to select the pro-
gramme and options again and to press button 7 .
At the end of the programme
The machine stops automatically. The blinking appears
on the display, the pilot light of button 7 and the pilot light
9 go off.
If a programme or an option that ends with water left in
the tub has been selected, the pilot light 9 remains on and
the door is locked to indicate that the water must be emp-
tied out before opening the door.
Follow the below instructions to empty out the water:
1. Turn the programme selector dial to .
2. Select the draining or spinning programme.
3. Reduce the spin speed if needed, by pressing the
relevant button.
4. Press button 7 .
At the end of the programme, the door is released and can
be opened. Turn the programme selector dial to to
switch the machine off.
Remove the laundry from the drum and carefully check
that the drum is empty. If you do not intend to carry out
another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
Stand By : If your laundry is not removed within 10 mi-
nutes after the programme is finished, the back light of
the display switches off and the energy saving system will
be enabled. Only the pilot light of the button 7 is blinking
to indicate that the appliance has to be switched off. By
pressing any button the appliance will come out from the
energy saving status and you can set another programme
or switch the appliance off.
Care and cleaning
Warning! You must DISCONNECT the appliance
from the electricity supply, before you can carry out
any cleaning or maintenance work.
Descaling
The water we use normally contains lime. It is a good idea
to periodically use a water softening powder in the ma-
chine. Do this separately from any laundry washing, and
according to the softening powder manufacturer's in-
structions. This will help to prevent the formation of lime
deposits.
External cleaning
Clean the exterior cabinet of the appliance with soap and
water only, and then dry thoroughly.
Cleaning the drawer recess
The washing powder and additive dispenser drawer
should be cleaned regularly.
Remove the drawer by
pressing the catch down-
wards and by pulling it
out. Flush it out under a
tap, to remove any traces
of accumulated powder.
To aid cleaning, the top
part of the additive com-
partment should be re-
moved.
13