ZyXEL Communications P-2608HWL-Dx Series - Manual (Page 163)

P-2608HWL-Dx Series User’s Guide
Chapter 11 SIP 163
URL Type Select whether or not to include the SIP service domain name when the ZyXEL
Device sends the SIP number.
SIP - include the SIP service domain name
TEL - do not include the SIP service domain name
Expiration Dura-
tion
Enter the number of seconds your SIP account is registered with the SIP register
server before it is deleted. The ZyXEL Device automatically tries to re-register your
SIP account when one-half of this time has passed. (The SIP register server might
have a different expiration.)
Register Re-send
timer
Enter the number of seconds the ZyXEL Device waits before it tries again to regis-
ter the SIP account, if the first try failed or if there is no response.
Session Expires Enter the number of seconds the ZyXEL Device lets a SIP session remain idle
(without traffic) before it automatically disconnects the session.
Min-SE Enter the minimum number of seconds the ZyXEL Device lets a SIP session
remain idle (without traffic) before it automatically disconnects the session. When
two SIP devices start a SIP session, they must agree on an expiration time for idle
sessions. This field is the shortest expiration time that the ZyXEL Device accepts.
RTP Port Range
Start Port
End Port Enter the listening port number(s) for RTP traffic, if your VoIP service provider
gave you this information. Otherwise, keep the default values.
To enter one port number, enter the port number in the Start Port and End Port
fields.
To enter a range of ports,
•
enter the port number at the beginning of the range in the Start Port field
• enter the port number at the end of the range in the End Port field.
Voice Compres-
sion
Select the type of voice coder/decoder (codec) that you want the ZyXEL Device to
use. G.711 provides higher voice quality but requires more bandwidth (64 kbps).
•
G.711A is typically used in Europe.
• G.711u is typically used in North America and Japan.
In contrast, G.729 only requires 8 kbps.
The ZyXEL Device must use the same codec as the peer. When two SIP devices
start a SIP session, they must agree on a codec.
Primary Compres-
sion Type
Select the ZyXEL Device’s first choice for voice coder/decoder.
Secondary Com-
pression Type
Select the ZyXEL Device’s second choice for voice coder/decoder. Select None if
you only want the ZyXEL Device to accept the first choice.
Third Compres-
sion Type
Select the ZyXEL Device’s third choice for voice coder/decoder. Select None if you
only want the ZyXEL Device to accept the first or second choice.
DTMF Mode Control how the ZyXEL Device handles the tones that your telephone makes when
you push its buttons. You should use the same mode your VoIP service provider
uses.
RFC 2833 - send the DTMF tones in RTP packets
PCM - send the DTMF tones in the voice data stream. This method works best
when you are using a codec that does not use compression (like G.711). Codecs
that use compression (like G.729) can distort the tones.
SIP INFO - send the DTMF tones in SIP messages
Outbound Proxy
Table 56 VoIP > SIP Settings > Advanced
LABEL DESCRIPTION