Zanussi ZWF 1231 W - Manual (Page 10)

10
To select Drain only, press the “Skip” button three
times, the wash - rinses - spin LED,s go out.
The drain LED only remains alight.
11 “Delay” button
This button makes it possible to delay the starting of the
programme selected from 30 min - 60 min - 90 min, 2
hours and then by 1 hour up to a maximum of 23 hours.
The delay you have selected is shown on the display for
about 3 seconds; afterwards, the duration of the
programme reappears.
You must select this option after you have set the
programme and before you press the “Start/Pause”
button.
The time value shown on the display will decrease by
one unit every hour.
You can change the delay time at any moment,
before you press the Start/Pause button.
If you have already pressed the Start/Pause button, and
you wish to cancel the delay time, proceed as follows:
• set the washing machine to Pause by pressing the
“Start/Pause” button;
• press the “Delay” button until the display shows the
symbole « 0’ ».
• press the “Start/Pause” button again.
Important!
The door will be locked throughout the delay time.
If you need to open the door, you must first set the
washing machine to Pause by pressing the
“Start/Pause” button. After you have closed the door,
press the “Start/Pause” button again.
Wash
Rinses
Spin
Drain
Prewash
12 Programme phase indicator
lights
When you select a programme, the lights relevant to the
phases that form the programme light up.
After you have started the programme, only the light
relevant to the phase that is currently being carried out
will remain lit.
Wash
Rinses
Spin
Drain
Prewash