3 status screen (ap mode) – ZyXEL Communications NBG-417N User Manual

Page 54

Advertising
background image

Chapter 5 AP Mode

NBG-417N User’s Guide

54

2

To set your NBG-417N to AP Mode, go to Maintenance > Sys OP Mode >
General and select Access Point.

Figure 24 Maintenance > Sys OP Mode > General

3

A pop-up appears providing information on this mode. Click OK in the pop-up
message window. (See

Section 22.4 on page 186

for more information on the

pop-up.) Click Apply. Your NBG-417N is now in AP Mode.

Note: You have to log in to the Web Configurator again when you change modes.

5.3 Status Screen (AP Mode)

Click on Status. The screen below shows the status screen in AP Mode.

Figure 25 Status Screen (AP Mode)

Advertising
See also other documents in the category ZyXEL Communications Hardware: