ZyXEL Communications Prestige 310 - Manual (Page 62)

Prestige 310 Broadband Sharing Gateway
5-2 Remote Node Setup
Table 5-1 Fields in Menu 11.1 (Ethernet Encapsulation)
Field Description Examples
Rem Node Name Enter a descriptive name for the remote node. This field can
be up to eight characters. LAoffice
Active Press the [SPACE BAR] to toggle between Yes and No and
activate (deactivate) the remote node. Yes
Encapsulation Ethernet is the default encapsulation. Press the [SPACE BAR]
if you wish to change to PPPoE encapsulation. Ethernet
Service Type Press the [SPACE BAR] to select from Standard, RR-Toshiba
(RoadRunner Toshiba authentication method) or RR-Manager
(RoadRunner Manager authentication method). Choose one of
the RoadRunner methods if your ISP is Time Warner's
RoadRunner; otherwise choose Standard. Standard
Service Name This is valid only when you have chosen PPPoE encapsulation.
If you are using PPPoE encapsulation, then type the name of
your PPPoE service here. poellc
Outgoing: My
Login This field is applicable for PPPoE encapsulation only. Enter the
login name assigned by your ISP when the Prestige calls this
remote node. Some ISPs append this field to the Service
Name field above (e.g., jim@poellc) to access the PPPoE
server. jim
Outgoing: My
Password Enter the password assigned by your ISP when the Prestige
calls this remote node. Valid for PPPoE encapsulation only. *****
Authen=
CHAP/PAP This field sets the authentication protocol used for outgoing
calls. Options for this field are:
CHAP/PAP - Your Prestige will accept either CHAP or PAP
when requested by this remote node.
CHAP - accept CHAP only.
PAP - accept PAP only.
CHAP/PAP
Server IP This field is valid for RoadRunner service type only. The
Prestige will find the RoadRunner Server IP automatically if this
field is left blank. If it does not, then you must enter the
authentication server IP address here.
Route This field refers to the protocol that will be routed by your
Prestige – IP only for the P310. IP
Edit IP This field leads to a “hidden” menu. Press the [SPACE BAR] to
select Yes and press [ENTER] to go to Menu 11.3 - Remote Yes