Interrupting a programme, Cancelling a programme, Opening the door when the programme has started – Zanussi ZWC 1300W User Manual

Page 13: At the end of the programme

Advertising
background image

- 13 -

Interrupting a programme

Press the Start/Pause button to interrupt a programme
which is running. The corresponding light starts to flash.
After approx. 1 minute the door can be opened. The pro-
gramme continues when you press the button again.

Cancelling a programme

Turn the programme selector to the ”Reset” position, to
cancel a pre-set programme. Now you can select a new
programme.

Opening the door when the programme
has started

Press the Start/Pause button. The door can be opened
after approx. 1 minute, when the following conditions are
observed:

The water temperature is below 55°C.

The water level is below the bottom edge of the door.

The machine doesn’t spin.

If it’s absolutely necessary to open the door and the con-
ditions above have been observed, you must switch the
machine off by turning the programme selector to the
”Reset” position. After approx. 1 minute can the door be
opened.

Pay attention that there can be remaining water in
the machine. This could spill out and be hot.

At the end of the programme

The machine stops automatically.
When the ”End” light is lit, the programme is finished.
The ”Door” light goes out, the door can be opened and
the laundry can be removed.

If the ”Rinse hold” option has been selected, the lights
”End” and ”Door” continue to be lit to indicate that the
water must be drained before opening the door.

To drain the water:

1. Turn the programme selector to the ”Reset”

position.

2. Select the programme ”Draining” or ”Spinning”.

You can reduce the spin speed by turning the
selector to avoid synthetic, wool or other fragile
materials becoming creased.

3. Press in the Start/Pause button.

4. When the ”Door” light goes out, the door can be

opened and the laundry can be removed.

5. Turn the programme selector to the ”Reset”

position.

If you do not intend to carry out any more laundry,
turn off the water supply and for safety reasons,
also disconnect the power supply to the machine.

Leave the door ajar, so that the remaining moisture
inside the drum can evaporate and prevent any
musty smells developing.

Advertising