Yamaha CBX-D5 - Manual (Page 72)

28 Chapter : 28 Chapter : Add-28
MIDI Data Format
1. Block Diagram of MIDI Reception/Transmission
<MIDI Reception Conditions>
* If the Host Selector switch is set to anything other than “MIDI”, the MIDI data are echoed back to HOST IN
→
MIDI OUT and MIDI IN
→
HOST OUT, respectively.
<MIDI Transmission Conditions>
* If the Host Selector switch is set to anything other than “MIDI”, the MIDI data are echoed back to HOST IN
→
MIDI OUT and MIDI IN
→
HOST OUT, respectively.
2. Channel Messages
Channel messages are not transmitted or received.
If the Host Selector switch is set to anything other than “MIDI”, the
MIDI data are echoed back to HOST
IN
→
MIDI OUT and MIDI IN
→
HOST OUT, respectively.
3. System Messages
The CBX-D5 handles System Exclusive messages like those below.
Digital Track Message (Note 1)
(Note 1) The Digital Track Message (hereafter referred to as DT) is comprised of the Yamaha System Exclu-
sive ID and a Digital Track Command, and is a System Exclusive message.
The Digital Track Messages used with this equipment are formatted as shown below.
General format for the Digital Track Message
11110000 F0
01000011 43 YAMAHA System Exclusive ID
01111000 78 YAMAHA System Exclusive Sub ID
<ab> *1 DT command
data bytes *2
11110111 F7
MIDI IN or
TO HOST
$F0,$43,$78,$41,$[ch#],$[pa/H],$[pa/L],$[bc/H],$[bc/L],$F7
PARAMETER REQUEST
$F0,$43,$78,$41,$[ch#],$[pa/H],$[pa/L],$[bc/H],$[bc/L],{$[d/H],$[d/L]},$F7
PARAMETER DUMP
MIDI IN or
TO HOST
$F0,$43,$78,$41,$[ch#],$[pa/H],$[pa/L],$[bc/H],$[bc/L],{$[d/H],$[d/L]},$F7
PARAMETER DUMP