ZyXEL Communications POWERLINE PL-100 - Manual (Page 4)

ENGLISH
3
Connecting the PL-100 to a Computer
1 Connect an Ethernet cable to the port on the PL-100.
2 Connect the other end of this Ethernet cable to the Ethernet port of your
computer.
3 Plug the PL-100 into a wall socket that is near your computer.
4 Confirm that the PWR, LINK and ETHN LEDs on the PL-100 are on.
Troubleshooting
The PWR LED is off when the PL-100 is plugged into an outlet.
• Make sure the outlet is working by plugging another electric device into it. If it
is working, plug in the PL-100 again. If the PL-100 LED still does not light,
contact our technical support.
The LINK LED is off and the PL-100 is not detecting another Homeplug device.