Zanussi ZWH 5105 - Manual (Page 25)

25
Installation instruction
Unpacking
All transit bolts and packing must be removed
before using the appliance.
You are advised to keep all transit devices so
that they can be refitted if the machine ever
has to be transported again.
1. After removing all the packaging, carefully
lay machine on it’s back to remove the
polystyrene base from the bottom.
2. Remove the power supply cable and the
hoses from the hose holders on the rear of
the appliance.
3. Unscrew the three bolts.
4. Slide out the relevant plastic spacers.
5. Open the porthole, take out the inlet hose
from the drum and remove the polystyrene
block fitted with the adhesive tape on the
door seal.Open the porthole, take out the
inlet hose from the drum and remove the
HEC0037 HEC0036
HEC0030
polystyrene block fitted with the adhesive
tape on the door seal.
6. Fill the smaller upper hole and the two large
ones with the corresponding plastic plug
caps supplied in the bag containing the
instruction booklet.
Positioning
Install the machine on a flat hard floor. Make
sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units. Level the washing machine by raising or
lowering the feet. The feet may be tight to adjust
as they incorporate a self locking nut, but the
machine MUST be level and stable.
Any necessary adjustment can be made with a
spanner.
Accurate levelling prevents vibration, noise and
displacement of the machine during operation.
Never place cardboard, wood or similar materials
under the machine to compensate for any
unevenness in the floor.
If necessary, check the
setting with a spirit
level.
Water inlet
Do not use the hose from your previous
machine to connect to the water supply.
HEC0025
132952260.qxd 20/05/2009 10.35 Pagina 25