Lubrication – Yazoo/Kees 968999694/ZEKH42200 User Manual

Page 56

Advertising
background image

English-

54

LUBRICATION

4. Deck outer spindle

Lubricate using a grease gun, one zerk, each
side 2-3 strokes.

Use only good quality bearing grease.

5. Engine Oil
Changing the Engine Oil

The engine oil should be changed for the first
time after 5-8 hours of operation. Thereafter,
it should be changed every 50 hours.

1.

Place the machine on a flat surface.

2.

Place a container under the engine where
the hose from the oil drain valve exits.

3.

Remove the dipstick and open the drain
valve.

4.

Allow the oil to run out into the container.

5.

Then close the oil drain valve.

6.

Replace the oil filter if necessary.

7.

Fill with new engine oil in accordance
with Checking the Oil Level.

8.

Start the engine. Run it for a few
seconds. Stop and re-check the oil level.

8011-733

Deck outer spindle

WARNING!
The engine and the exhaust
system, become very hot
during operation.
Risk for burns if touched.
Allow engine and exhaust
system to cool at least two (2)
minutes.

IMPORTANT INFORMATION
Used engine oil is a health hazard and
must not be disposed of on the ground or
in nature; it should always be disposed
of at a workshop or appropriate disposal
location.
Avoid skin contact; wash with soap and
water in case of spills.

8011-730

Oil drain valve

Advertising
This manual is related to the following products: