ZyXEL Communications 480 - Manual (Page 44)

Prestige 480 ISDN Router
2-14 Hardware Installation and Setup
At this point, the Prestige asks if you wish to test your ISDN. If you select Yes, the Prestige will
perform a loop-back test to check the ISDN lines. If the loop-back test fails, please note the error
message that you receive and take the appropriate troubleshooting action.
Figure 2-13 Loopback Test
2.12 Ethernet Setup
This section describes how to configure the Ethernet using Menu 3 – Ethernet Setup. From the
Main Menu, enter 3 to open Menu 3.
Figure 2-14 Menu 3 - Ethernet Setup
Menu 3 - Ethernet Setup
1. General Setup
2. TCP/IP and DHCP Setup
Enter Menu Selection Number:
Setup LoopBack Test...
Dialing to 40000 ...
Sending and Receiving Data ...
Disconnecting...
LoopBack Test OK
### Hit any key to continue. ###