Optional i/o cards, Supported i/o cards, Controls and connectors – Yamaha TX5n User Manual
Page 9
TX6n/5n/4n Reference Manual
9
Controls and Connectors
@4
[NETWORK] connector
This is a 100BASE-TX/10BASE-T Ethernet connector. You can connect this to a computer so that the amplifier can be mon-
itored and controlled from Amp Editor. This also allows an external controller such as AMX or Crestron to be connected.
• To prevent electromagnetic interference, use an STP (Shielded Twisted Pair) cable for the [NETWORK] connector.
@5
[FAULT OUTPUT] connectors
This is a 3P Euroblock connector for controlling an external analog device when an abnormality occurs in the CPU or trig-
gered by the occurrence of a Fault event specified in Amp Editor. NC and C will be connected when the amplifier is operat-
ing normally; NO and C will be connected when a problem occurs
. You can also reset this output from Amp
Editor.
A message will appear in the screen if a problem occurs. To reset the output, hold down the [EXIT] button for three seconds
or longer in the HOME screen.
@6
Power cable
Connect the plug of the power cable to an AC outlet of the correct voltage.
@7
Grounding screw
The AC power cord is a 3-wire type. If the AC outlet used is earthed (grounded), this device will be properly earthed as well.
Also, grounding the screw sometimes reduces hum and interference noise.
■ Supported I/O cards
You can remove the AES-IO card from the TXn’s rear panel, and install a separately sold MY (mini-YGDAI) card. As of Sep-
tember 2009, the following MY cards are supported. For the latest information, refer to the Yamaha pro audio website.
* When the card which supports Emulation mode is operating with the mode ON, the compatibility is the same as the emulated card.
Optional I/O cards
Card name
Input/output format
Number of channels
Auto Scan Mode/
Redundant Backup
Input/output connector
Inputs
Outputs
AES-IO (attached)
AES/EBU
2
2
✓
XLR-3-31, XLR-3-32
MY4-AD
Analog input
4
—
—
XLR-3-31
MY8-AD24
Analog input
8
—
—
TRS phone
MY8-AD96
Analog input
8
—
—
D-sub 25-pin
MY4-DA
Analog output
—
4
—
XLR-3-32
MY8-DA96
Analog output
—
8
—
D-sub 25-pin
MY8-ADDA96
Analog input/output
8
8
—
Euroblock
MY8-AE
AES/EBU
8
8
✓
D-sub 25-pin
MY8-AE96
AES/EBU
8
8
✓
D-sub 25-pin
MY8-AE96S
AES/EBU
8
8
✓
D-sub 25-pin
MY8-AEB
AES/EBU
8
8
✓
BNC
MY16-AE
AES/EBU
16
16
✓
D-sub 25-pin
MY16-CII
CobraNet
16
16
—
RJ-45
MY16-ES64
EtherSound
16
16
— *
RJ-45
MY16-MD64
MADI
16
16
— *
BNC, SC fiber
MY16-EX
Expansion card
16
16
— *
RJ-45
AVY16-ES
EtherSound made by
AuviTran Corp.
16
16
—
RJ-45
NOTE