Yamaha RX-V10 - Manual (Page 20)

18
6
Select the center channel output mode suitable for your
speaker configuration.
(Refer to “SPEAKER CONFIGURATION” on page 6.)
On the feature of each mode, refer to the “Note” shown
below.
7
Note
In step 6, when you select the center channel output mode,
note the following.
For 5 speaker configuration)
NORMAL: Select this mode when you use a center speaker
that is smaller than the front speakers. In this
mode, the bass tone will be output from the front
speakers.
WIDE: Select this mode when you use the center speaker
approximately same sized as the front speakers.
For 4 speaker configuration)
PHANTOM: Select this mode when you do not use the center
speaker. The center sound will be output from the
left and right front speakers.
8
Turn up the volume.
You will hear a test tone (like pink noise) from the left front
speaker, then the center speaker, then the right front
speaker, and then the rear speakers, for about two seconds
each. The display changes as shown below.
* The test tone from the left rear speaker and the right
rear speaker will be heard at the same time.
9
Adjust the BALANCE control so that the effect sound
output level of the left front speaker and the right front
speaker are the same.
Flashes continuously.
VOLUME
CENTER
MODE
TEST
TEST
NORMAL
WIDE
PHANTOM
REC/PAUSE DIR B DIR A PLAY
DISC
POWER VOLUME
PLAY
DVD/LD
2CH/5CH
PRESET A/B/C/D/E – +
LEVEL
DELAY/REAR
/CENTER TEST EFFECT
PROGRAM PROLOGIC ENHANCED
– +
SLEEP
TAPE A/B
ON/OFF
TUNER
CD
PHONO
VCR
8
7
9 6
(L and R)
BALANCE
L R