Yard Machines 2- Cycle Gas Cultivator - Manual (Page 9)

9
SECTION 3: ASSEMBLY INSTRUCTIONS
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13
Throttle Wire Hole
Throttle
Wire Slot
Throttle Cable Assembly
1. Wrap the throttle wire once around the handlebar.
See Figure 9.
2. Depress the throttle trigger and locate hole for the
throttle wire. See Figure 10.
3. With the throttle trigger depressed, place the barrel
end of the throttle wire inside the hole of the trigger.
See Figure 11.
4. Release the throttle trigger and guide the cable up
into the slot of the trigger housing.
5. Push the throttle cable housing into the trigger
housing until it snaps into place. See Figure 12.
6. Route the throttle cable through the clip on the right
handlebar mounting bracket. See Figure 13.
NOTE: Ensure the throttle cable fits properly into the
guide at the carburetor plate on the engine. If it
does not, the throttle will not work properly. See
Figure 9.
Throttle Cable
Carburetor
Plate Guide
Mounting
Bracket
Throttle
Cable
Engine