Zoom 4420-A - Manual (Page 27)

Chapter 4. Wireless Configuration 27
WDS Settings
A Wireless Distribution System (WDS) expands a wireless
network by using multiple Access Points
connected wirelessly.
All APs must use the same channel.
Note: Most users who want to configure the AP+4 as a repeater
should choose Universal Repeater Mode (see Wireless Basic
Settings, page 20) instead of WDS, because a Universal
Repeater is easier to set up and provides the best performance.
Parameter Select or enter . . .
Enable WDS Select the check box to enable WDS.
Add WDS AP Enter Access Point MAC addresses, one at a
time.
• Click Apply Changes after each entry. The
AP MAC addresses appear one at a time in
the Current WDS AP List.
• Click Reset to clear the current entry before
you apply the change.
• Click Set Security to open the Wireless
Security Setup page and configure
security for the additional AP. The security
method must be the same as on the AP+4.